Hex. nut M8
P 5 / 8
Fig. 12
Fig. 13
Fig. 14
Spring pin extractor 4.0
Plastic hammer
Spring pin 4x20
M14 Screw
Table
When removing M14 Screw from the front vice section;
1) Press the end of M4 Screw against table to compress
Compression spring 10.
2) At the same time, push out 4-20 Spring pin in M14 Screw
using Spring pin extractor 4.0 (Makita part No. 1R308).
See Fig. 12.
[7] Adjustment
Note: The following information applies to the products including 16.5mm cutter chain as the standard accessory.
Front edge of Indication
plate (yellow)
Front end of 16.5mm
cutter chain
Pan head screw M4x8
Bottom of Base
complete
Indication plate
Slide Indication plate
backward or forward.
1) Fix an yellow colored Indication plate to Base complete with M4x8 pan head screw as shown in Fig. 13 after aligning
the front edge of the Indication plate with front end of 16.5mm cutter chain.
2) When aligning the center of + Countersunk head screw M6x12 with the bottom of Base complete, drive Stopper pole
into the Base complete by hand in order to adjust the height of Rotor holder at ZERO position on Stopper pole as
shown in Fig. 14. After positioning it, tighten M8 Hex. nut onto the hole of Base complete firmly using Wrench.
Note: Face the gauge of Stopper pole to outside before tihgtening M8 Hex. nut.
3) Align the left end of Scale plate with the left end of the cutter chain by resetting the scale plate on the Base complete.
See Fig. 15.
0
2
4
5
6
5
6
8
Fig. 15
Left end of 16.5mm
cutter chain
Left end of Scale plate
Scale plate
0
2
4
5
6
Stopper pole
Base complete
Center of + Countersunk
head screw M6x12
Gauge of the Stopper
pole
"ZERO" mark
R
epair
Threads of the
Stopper pole
Rotor holder
