4
ENGLISH (Original instructions)
Explanation of general view
1-1. Wing bolt
1-2. Stopper pole
1-3. Stopper
2-1. Lock-off button
2-2. Switch trigger
3-1. Adjusting screw
3-2. Chain bar
3-3. Chain cover
3-4. Hex bolt
4-1. Arrow
4-2. Sprocket
4-3. Hex bolt
6-1. Lever (A)
6-2. Vise lever
6-3. Rear vise
7-1. Setting handle
7-2. Front vise
8-1. Indicator plate
8-2. Indication plate
8-3. Cutting line (A)
8-4. Cutting line (B)
9-1. Hook
10-1. Hex bolts
10-2. Gauge plate
10-3. Travel distance (D)
10-4. Lever (B)
11-1. Lever (C)
12-1. Adjusting hex bolt for No. 1 set
position
12-2. Lever (C)
12-3. Adjusting hex bolt for No. 2 set
position
13-1. Original position
13-2. No.1 set position
13-3. No.2 set position
13-4. Indication plate
13-5. Ruler
14-1. Front base
16-1. Limit mark
17-1. Brush holder cap
17-2. Screwdriver
SPECIFICATIONS
Model 7104L
Max. hole length (Longitudinal)
130 mm
Capacities
Max. hole depth
155 mm
Width of applicable workpiece
80 mm - 308 mm
Chain speed
300 m/min
Dimensions (L × W × H)
512 mm × 298 mm × 513 mm
Net weight
17.3 kg
Safety class
Class I
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
ENE062-1
Intended use
The tool is intended for cutting mortise in wood.
ENF001-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the
operator from electric shock. Use only three-wire
extension cords which have three-prong grounding-type
plugs and three-pole receptacles which accept the tool's
plug.
ENG905-1
Noise
The typical A-weighted noise level determined
according to EN61029:
Sound pressure level (L
pA
) : 90 dB (A)
Sound power level (L
WA
) : 103 dB (A)
Uncertainty (K) : 3 dB (A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN61029:
Vibration emission (a
h
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
•
The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
•
The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
•
Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).