P 9/16
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Casing Assembly and Feeder Box Assembly (cont.)
R
epair
ASSEMBLING
8) Casing complete can be assembled by doing the reverse of the disassembling steps. (Fig. 7 to Fig. 2 on pages 4 to 3)
Note: Be sure to follow the instructions described in Fig. 25 to Fig. 27.
Fig. 25
Fig. 26
Fig. 27
U-groove
Spring pin 4-12
of Casing complete
Steel ball 3.5
Dial 42
Assembling Dial 42 to Shifter pin
Assembling Plate to Stopper base
Assembling Sleeve 4 to Casing complete
Shifter pin
M4x28 Thumb screw
By placing Shifter pin so that the pin's flat faces towards
the side where M4x28 Thumb screw is mounted,
Spring pin 4-12 of Casing complete fits in the U-groove
of Dial 42 when Dial 42 is assembled to Shifter pin.
Important:
Click stop of Dial 42 does not work without Steel ball 3.5.
Therefore, before assembling Dial 42 to Shifter pin,
make sure that Steel ball 3.5 is mounted in place on
Casing complete.
Plate
Stopper base
Feeder box
Lever
Lever
While pressing down two Levers at the same time,
push Stopper base towards Feeder box until it stops,
then hitch Plate to Stopper base.
Sleeve 4 is not reversible when assembled to Casing complete.
Be sure to do as illustrated in "Correct".
While pressing down two Levers at the same time,
pull Stopper base slowly back to the initial position.
Plate is now assembled in place.
M3x5 Shoulder
flat head screw
Casing complete
[cross section
of Sleeve 4]
Sleeve 4
Casing complete
Sleeve 4
Correct
Wrong
M3x5 Shoulder
flat head screw
outside of
Casing complete
The M3x5 Shoulder
flat head screw cannot
be fastened in place.
