R
epair
P 3 / 14
M5x18 Hex
socket head bolt
Base
Torsion spring 6
Tool opener
M4 + Pan head screw
M4 + Pan head screw
[2] Disassembling Tool opener
[3] Assembling tool opener
Fig. 1
Fig. 2
The tail of
torsion spring 6
Blade holder
Tool opener
Gear housing cover
Gear housing
Viewed from Blade holder side
[4] Disassembling Handle section
Tool opener
Safety wire
Slotted screwdriver
Fig. 3
Fig. 4
Tool opener hinge portion
Fig. 5
4x18 Tapping screw
Hook of Handle L
Hook of
Handle R
Notch of Motor housing
4x50 Tapping screw
(Refer to Fig. 5.)
4x50 Tapping screw
installation hole
4350T, 4350CT: 4x18 Tapping screw
4350FCT: 4x40 Tapping screw
1. Separate Handle R from Housing L by the following steps.
(1) Remove Tapping screws as illustrated in Fig. 4.
(2) Gently lift up the 4x50 Tapping screw installation side of Handle R with slotted screwdriver to remove the hooks of
Handles L and R from the notch of Motor housing. (Fig. 5)
Note: Take care not to break the hooks, the protrusion and the depressions when disassembling.
2. LED circuit (only for 4350FCT) and Safety wire can be removed together. As for removal of Safety wire, open Tool
opener and remove both tails of Safety wire from the holes of Gear housing cover behind Handles L and R.
1. Install Torsion spring 6 into the depression on Gear housing cover around Tool opener hinge portion, and then fasten
Tool opener to Gear housing cover with M4 + Pan head screw.
2. Turn the tail of Torsion spring 6 clockwise using thin flat screwdriver to set it in place. (Fig. 3)
1. Remove M5x18 Hex socket head bolt. Base is separated from product. (Fig. 1)
2. Remove M4 + Pan head screw. Tool opener and Torsion spring 6 are separated. (Fig. 2)
