6
Symbols
END201-5
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
........Read instruction manual.
....................DOUBLE INSULATION
Intended use
ENE019-1
The tool is intended for the sawing of wood, plastic and
metal materials. As a result of the extensive accessory
and saw blade program, the tool can be used for many
purposes and is very well suited for curved or circular
cuts.
Power supply
ENF002-2
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
GEA005-3
WARNING Read all safety warnings and all
instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
Keep work area clean and well lit.
1.
Cluttered or dark
areas invite accidents.
Do not operate power tools in explosive
2.
atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools
create sparks which may ignite the dust or fumes.
Keep children and bystanders away while
3.
operating a power tool.
Distractions can cause you
to lose control.
Electrical safety
Power tool plugs must match the outlet. Never
4.
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
Avoid body contact with earthed or grounded
5.
surfaces such as pipes, radiators, ranges and
refrigerators.
There is an increased risk of electric
shock if your body is earthed or grounded.
Do not expose power tools to rain or wet
6.
ENGLISH (Original instructions)
Explanation of general view
Lock button
1.
Switch trigger
2.
Lower
3.
Higher
4.
Speed control screw
5.
Blade holder
6.
Blade set
7.
Bolt
8.
Hex wrench
9.
Blade shank
10.
Blade
11.
Universal blade clamp
12.
Universal shank blade
13.
Spring pin
14.
Hole
15.
Retainer
16.
Roller
17.
Screw
18.
Dust cover
19.
Guide rule (Rip fence)
20.
Circular guide
21.
Knob
22.
Fit pin into the hole
23.
Pin for circular guide
24.
Base
25.
Cutting line
26.
Bevel angle
27.
Edge of housing
28.
Starting hole
29.
Cutting oil
30.
Grease
31.
Limit mark
32.
Screwdriver
33.
Brush holder cap
34.
SPECIFICATIONS
Model
4300BA
4300BV
Length of stroke
26 mm
26 mm
Max. cutting capacities
In wood at 90°
55 mm
55 mm
In wood at 45°
35 mm
35 mm
In steel at 90°
6 mm
6 mm
Strokes per minute (min
-1
)
3,100
0 - 3,100
Overall length
225 mm
225 mm
Net weight
2.4 kg
2.5 kg
Safety class
/II
Due to our continuing programme of research and development, the specifications herein are subject to change
•
without notice.
Specifications may differ from country to country.
•
Weight according to EPTA-Procedure 01/2003
•
