![background image](http://html.mh-extra.com/html/makita/3707f/3707f_instruction-manual_230013008.webp)
8
•
When using the trimmer shoe, the straight guide or the
trimmer guide, be sure to keep it on the right side in the
feed direction. This will help to keep it flush with the side
of the workpiece.
CAUTION:
•
Since excessive cutting may cause overload of the motor
or difficulty in controlling the tool, the depth of cut should
not be more than 3 mm (1/8”) at a pass when cutting
grooves. When you wish to cut grooves more than 3 mm
(1/8”) deep, make several passes with progressively
deeper bit settings.
Templet guide
The templet guide provides a sleeve through which the bit
passes, allowing use of the trimmer with templet patterns.
Loosen the screws and remove the base protector. Place the
templet guide on the base and replace the base protector.
Then secure the base protector by tightening the screws.
Secure the templet to the workpiece. Place the tool on the
templet and move the tool with the templet guide sliding
along the side of the templet.
NOTE:
•
The workpiece will be cut a slightly different size from the
templet. Allow for the distance (X) between the router bit
and the outside of the templet guide. The distance (X)
can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - router
bit diameter) / 2
1. Feed direction
2. Bit revolving direction
3. Workpiece
4. Trimmer shoe, straight guide
1
2
3
4
001985
001986
1. Screws
2. Base protector
3. Screwdriver
4. Screws
1
2
3
4
001987
1. Straight bit
2. Base
3. Templet
4. Distance (X)
5. Workpiece
6. Templet guide 10
1
2
3
4
5
6
10mm(3/8")
001988