Makita 0088381679374, Instruction Manual, Page: 4 / 56

4 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model DFL201F DFL301F DFL402F
Fastening torque Hard joint 8 - 20 N·m 16 - 30 N·m 25 - 40 N·m
Soft joint 8 - 20 N·m 16 - 30 N·m 25 - 40 N·m
Square drive 9.5 mm 9.5 mm 9.5 mm
No load speed (min
-1
) 360 260 200
Overall length
(Depending on the battery)
417 - 429 mm 465 - 477 mm 465 - 477 mm
Net weight 1.5 - 2.1 kg 1.7 - 2.1 kg 1.7 - 2.1 kg
Rated voltage D.C. 14.4 V
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge BL1415N / BL1415NA / BL1430 / BL1430B / BL1440 / BL1450 /
BL1460A / BL1460B
Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-2:
Model DFL201F, DFL402F
Sound pressure level (L
pA
) : 72 dB(A)
Uncertainty (K) : 3 dB(A)
Model DFL301F
Sound pressure level (L
pA
) : 74 dB(A)
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-2:
Work mode: screwdriving without impact
Vibration emission (a
h
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE:
The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.