8
SPECIFICATIONS
Model
LF1000
Blade diameter
260 mm
Blade body thickness
1.8 mm - 2.0 mm
Riving knife thickness
2.2 mm
Hole diameter
For European countries
30 mm
Max. Cutting capacities (H x W) with blade 260 mm in diameter in the miter saw mode
Miter angle
Bevel angle
0°
20 mm x 180 mm
0°
68 mm x 155 mm
45° (left)
50 mm x 150 mm
Max. Cutting capacities at 90°in the table saw (bench saw mode)
70 mm
No load speed (min
-1
)
2,700
Table size (W x L)
500 mm x 555 mm
Dimensions (L x W x H1(note 1)/H2(note 2)) at miter saw mode
660 mm x 650 mm x 1,220 mm / 800 mm
in table saw mode
660 mm x 650 mm x 1,060 mm / 845 mm
Net weight
36 kg
Safety class
/II
Note1 H1: Height up to the tool head
Note2 H2: Height up to the table
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END213-8
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE
INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come to
a complete stop.
･
Do not place hand or fingers close to the
blade.
･
For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･
Unplug the tool before turning it over
around the axis.
･
Position hands properly when carrying.
･
Do not lift up the top end of the rip fence
when installing or removing it.
･
To loosen the bolt, turn it clockwise.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately
and returned to an environmentally
compatible recycling facility.
ENE061-1
Intended use
The tool is intended for accurate straight and miter
cutting in wood. The tool can be used both in miter saw
mode and in table saw mode by turning over the table
around its axis.
ENF002-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
