MAKINEX MS-150
Operator’s Manual Rev0322
Page 6 of 15
3. When fitting the Mixer make sure the Slider Clamp is opened. Fit the Mixer through the
gap at the front and then position the collar part of the Mixer between the Slider Clamp
and tighten.
4. Connect Helix Paddle to Mixer output shaft and firmly tighten using 22mm spanner.
The MS-150 is supplied with a short Helix Paddle (up to 3 bag mix) and a large Helix
Paddle (4 - 6 bag mix). Adjust height of Clamp Arm if necessary if Helix Paddle is
touching base of Bucket.
NOTE: Always grab the mixer by the handles and make sure the mixer is securely
tightened, but do not over-tighten!
Adjustable Slider Clamp
Clamping
Lever
Helix Paddle
Slide Arm
Collar
Clamp Arm
Collar
Thumb
Screw
Tighten Helix
Paddle with
22mm
spanner
