MAKERGEAR M3-ID, User Manual

Page: 3 / 20

1
Welcome
Your MakerGear M3-ID 3D Printer has arrived!
Do not change the M3-ID’s firmware unless you know exactly
what you’re doing or have been instructed to do so by
MakerGear support.
This User Guide can also be found on the MakerGear website at
setup.makergear.com , where you can access additional,
more specific information and resources.
Following minimal setup, your M3-ID is ready to print out-of-the-box. To
ensure safety as well as high quality printing, carefully follow the setup
instructions included in this User Guide.
This printer was assembled at the MakerGear shop in Beachwood, Ohio,
USA, and was tested for at least six hours to ensure that it was fully
operational at the time of shipping.
Do not remove the film of yellow polyimide tape from the
M3-ID’s glass build plate; this functions as the print surface,
and should be facing up.