4
MakerBot Replicator
MakerBot
4
MakerBot Replicator Z18
MakerBot
Remove the four (4) Torx screws
using a T15 driver
Remove three (3) button heads
screws by using a 2.5mm hex
screwdriver
Unplug the
HDMI Cable
from the
left side of the
User Interface
Assembly
Detach the three (3) wires
(
Camera
, right/left
LED Wires
)
from the back of the
User
Interface Assembly
Push the
Drawer
back and swing
around to unhook and remove the
Drawer
Note: DO NOT remove the
shoulder screw that is holding the
spring in the Drawer Assembly. It
can be potentially dangerous
Step 6 - Remove the User
Step 5 - Remove the Filament
Drawer Assembly
Slide Bottom
Filament Guide
Tube
out of the plastic clips
located on the front
Left Upright
.
Note: Follow the same steps in
the Replicator Desktop Printer
section to disassemble
User
•
•
•
•
•
•
