STEP THREE:
Wearing heat resistant gloves
remove the hot Experimental
Extruder from the 3D printer
carriage and place into the
Experimental Extruder Jig.
STEP FOUR:
Use the large side of one
Nozzle Wrench to grasp the
flats on the thermal core cone
(
adjacent to the Nozzle
).
STEP TWO:
Attach the Experimental Extruder
to the carriage of your MakerBot
3D printer and run the
Preheat function.
PRO TIPS:
Some materials may cling to the
Nozzle, to avoid this load and then
unload MakerBot PLA filament to
purge the Nozzle.
Once hot, you may want to scrape any
caked filament off of the Nozzle using
forceps or another tool.
CAUTION:
Always wear heat resistant gloves
and protective eyewear when
handling a hot Nozzle.
PAGE 3
EXPERIMENTAL EXTRUDER CONFIGURATION AND NOZZLE CHANGING GUIDE
Summary of Contents for Labs Experimental Extruder
Page 6: ......
