ASSEMBLY INSTRUCTIONS
Note:
Ensure filament
winds over the top of
the spool.
3. REMOVE THE SPOOL AXLE FROM THE
MAKERBOT FILAMENT CASE AND LOAD
A FILAMENT SPOOL.
4. INSERT A FILAMENT GUIDE TUBE INTO
ONE OF THE GUIDE TUBE ADAPTERS.
1. INSERT THE GUIDE TUBE ADAPTERS INTO
THE GROMMETS ON THE FILAMENT CASE.
2. OPEN THE CASE BY DEPRESSING
THE LATCH.
5. ROUTE FILAMENT THROUGH THE
GUIDE TUBE.
6. INSERT THE LOOSE END OF THE GUIDE
TUBE INTO THE PORT AT THE TOP LEFT
SIDE OF THE MAKERBOT REPLICATOR Z18.
Summary of Contents for FILAMENT CASE
Page 4: ...www makerbot com...