10. Attach the Z motor bracket to the Z axis assembly using the four
silver bolts
and
locking nuts
. Hold the nut with the
flat wrench
and tighten from the top using the
2.5mm hex wrench
.
11. Ensure that the gears are level, with the belt between them.
If they are not level, loosen the set screws on the gear that is
taller, and push it down until it is level with the other
gear. Re-tighten the grub screws at the new height.
12. Attach the
router clamp
to the Z axis assembly using the bolts that are screwed into
the clamp. Unscrew them and attach the clamp to the Z axis assembly as shown with
3mm hex wrench
.
Drew’s Note: Be sure that your belt is tight
and level between the gears! If the belt
is loose or not level, the Z axis on your M2
will not move properly.
Router clamp
Z Axis
Bag C
Assembly Tools
Bag I
10
