Makel MSA-CM Series, User Manual

Page: 26 / 48

4 Detailed Functions Description
Table 5: Parameters in Channel's General configurations page.
Parameter Description Values
Use working duration counter? Selects if working time counter is to be
used for the channel. Possible values:
*No
Yes
16
Limit to send alert message
(hours) The amount of time after which a
message must be sent via
“Working
t. limit reached Ind.”
CO.
Min: 0h
Max: 500000h
Default: 1000h
16 Output status to measure Defines which is the channel status to be
measured. Possible values:
*On
Off
16 Counter direction Defines if the counter must count from 0
to
Limit or from Limit to 0.
Possible values:
*Increment
Decrement
The parameter “Limit to send alert message (hours)” defines the limit after which a message must be
issued informing that the limit has been reached. The parameter “Output status to measure” selects
which is the output status that must be measured as working.
4.2.3 O
[x]
: Scenes
The related COs are:
[input] “Scene Control”
: sets a scene or requests learn;
All the Channels have available from “Scene 1” to “Scene 32” for configuration. Each of the scenes can
be configured to a specific action that may, or may not, depending on the installation settings, change at
run time. In case changes can be made after configuration with ETS, those changes are persistent, which
16 Visible if “Use working duration counter?” set to “Yes.”
User’s Manual Page 26
Figure 7: Channel's Measurements configuration page.