※
With many parts contained in this product, please assemble the Ultimate2.0 exactly as the steps in this instruction to avoid confusion.
Pay especially attention to the mark of "O" and "X". Make sure you are doing exactly as required by the diagram marked with "O", other-
wise the parts may be broken and the robot may fail to work normally.
Diagram
Me RJ25 Adapter
Battery Information
Ultimate 2.0 requires six 1.5V AA alkaline batteries (Not included).
IMPORTANT BATTERY INFORMATION:
• Use only fresh batteries of the required size and recommended type.
• Please respect the correct polarity, (+) and (-).
• Do not try to recharge non-rechargeable batteries.
• Do not throw batteries into fire.
• Replace all batteries of the same type/brand at the same time.
• The supply terminals are not to be short-circuited.
• Batteries should be replaced by adults.
• Remove batteries if the robot is not going to be played with for some time.
LOW BATTERY INDICATORS:
Basic Knowledge --
Electronic Modules
Basic Knowledge --
Assembly Tip
The Me RJ25 Adapter module converts the standard RJ25 port into six pins (VCC, GND, S1, S2, SDA, and SCL) so that they can be easily drawn out from Makeblock
port in compatible with electronic modules from other manufacturers, such as temperature sensor and servo module.
• Do not mix old and new batteries, or use different types of batteries.
When the batteries grow weak, Ultimate 2.0 robot kit will move
much slower than usual, or even restart its mainboard. At this
time, power off the robot and replace all batteries.
8
9
Enable connections with electronic modules from
other manufacturer
Features:
3
(1)
(1)
(2)
Assembly Step
Parts that are required
in this step
Part Name
Part Number
Quantity
Notes
Assembly Path
Assembled
Diagram
Encoder Motor
185RPM
Encoder Motor 185RPM
M3×8
25mm DC Motor
Bracket
Pay attention to direction
of the motor interface.
