mScara User Guide
11/ 17
Initial position axle side view, see (e) for the initial position corresponding to the software.
d
）
.
Setting of steering engine pen lift and fall parameter
As shown in the figure, respectively enter the value by Pen up and Pen Down of the software,
click PenUp and PenDown
. When the following effect is observe and obtained, it is possible to set
pen lift mechanism of the steering engine (note: If the rudder arm of the steering engine does
not have the following angle, remove the rudder arm by a cross screwdriver to adjust installation
angle, the rubber band is adjusted for degree of tightness according to requirement, and
pendown is subject to just contact with the paper
.
