Make Mendel MegaBot, Manual

Page: 9 / 29

MAKE MENDEL Page 9
1 Universal Travel Adaptor
1 SMPS
2 Kapton Tapes (50mm + 15mm)
1 Magnetic Leveler
1 10m sample PLA
2 M8 Threaded Rod -285mm
1 Spool Holder-125mm
4 Smooth Rod(8mm Dia)-333mm
1 Paper Tape 50mm wide
1 Allan Key 2
(M4-GrubScrew, MK7)
1 Allan Key 2.5
(M3 Socket Cap Head)
1 Allan Key 3
(M4 Socket Cap Head)
1 Wrench 5mm, 7mm
(For M3 and M4)
NOTE:

Dummy Rails: Dummy rails are given for maintenance purpose, if you will need in future. Be
careful while removing the LM block from the Rail. Put dummy rail on block before removing it.

4 pin Molex Connector: We give one extra.
 Cooling Fan: Cooling Fan are needed for ABS , If you are using PLA there is no need of Cooling fan

Hotend: We provide are pre-solder Hotend

End Stops: When you press Print button, basically all 3 axis move to its HOME position. HOME
position is detected by Mechanical Switch. When switch is pressed, then printer understands that,
it has reached its home.
So there are 3 mechanical switch, 1 for each axis(X,Y,Z).
So, there is a Z Flag, which should go into the Z Optical switch, If z switch is moved during
shipping, then adjust it, so that it is pressed when nozzle is around 0.2 mm distance from
PrintBed..