MAJORSINE Inverter Manual / M101.4
Page 12
3-3 Front Panel
http://www.majorpower.com
Tel: 514.369.4919 Fax: 514.369.4817
MAJORPOWER.COM
¾
ON/OFF buttons
:
These are the two power buttons for turning on or turning off
the inverter.
Once the inverter is on, the “ON” button works as the On-Line
<=> Off-Line mode switching button.
¾
INVERTER ON
Indicates the INVERTER has been turned on
and is working normally (output is available to support load
equipment).
¾
OVERLOAD
Means that the inverter is in overload condition,
or that there is an output short circuit.
¾
DC ABNORMAL
Means that the input DC voltage is
“abnormal” and requires verification.
¾
FAULT
Indicates that the inverter is in “fault” condition. See
Section
6-3 Alarms
**If utility by-pass is not being used, and AC input is not
present, the fault LED will remain on.
¾
LCD Display Selection Buttons
The following data: (output voltage, output frequency, load,
input dc voltage, bypass ac voltage, bypass ac frequency, etc.)
and system status can be shown sequentially on the LCD
display by pressing these two buttons.
For more information – Refer to Section 5 Operation
