Major MJ-C10, Installation Manual, Page: 25 / 44

Installation, Operation and Parts Manual
MJ-C10
25
5.2 Operation instructions
Only one operator is allowed to work around the vehicle lift.
Always engage the safety locking mechanism before any operation on the lifted vehicle.
Do not make any operation on the lifted vehicle at a height under the first latching position (less than 500mm).
Never attempt to lower the lifted vehicle to the bottom when any of its wheel is removed unless you are assured that no damage
will occur.
To avoid personal injury and/or property damage, permit only trained and qualified personnel to operate the lift. After reviewing
these instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift. Always lift
the vehicle using all four adapters. Never raise just one end, one corner or one side of vehicle adapters.
Raise the lift
Make sure vehicle is neither front nor rear heavy and center of balance should be midway between adapters and centered over the
lift.
1. Park the vehicle between two posts.
2. Adjust the lifting arms until lifting adapters are under the pick‐up positions of the vehicle and make sure the gravity of vehicle located
over the center of four lifting arms.
3. Push the”UP”button until lifting adapters have touched the pick‐up positions of vehicle.
4. Keep on raising the vehicle making its wheels have a bit clearance off the ground and check again the stability.
5. Raise the vehicle to the excepted height, push the “Lowering handle” to engage the mechanical safety locking unit. Check again the
stability before doing maintenance or repair work underneath.
Lowering
When lowering the lift pay careful attention that all personnel and objects are kept clear.
1. Push the “UP” button to disengage the mechanical locking unit.
2. Push down the unlocking handle to release mechanical locking unit and meanwhile push down the lowering handle.
3. When the lift is fully lowered, position the lift arms and adapters to provide an unobstructed exit before removing vehicle from lift area.
POS. Descriptions Function
1 Unlocking handle Release the mechanical locking unit.
2 Lowering handle
Control descending movement.
Engage the mechanical locking unit.
3 UP button Push to control the rising movement.