53D0419
Designer Series Gas Fireplaces
31
LoG PLaCEMENT
INSTaLL LoGS aND RoCK wooL (EMBER MaTERIaL) IN FIREBox
1. Remove glass frame.
Refer to Glass Frame Removal, Page 31.
2. Carefully remove logs from wrapping.
3. Place left log (#1) on left end of grate. Line up two (2) pin holes in bottom of log with two (2) pins
on grate. Log #1 will always be to the left of the control panel.
Figure 41
4. Place right log (#2) on right end of grate. Line up three (3) pin holes in bottom of log with three
(3) pins on grate.
Figure 42
Before you begin
— This unit is supplied with eight ceramic fiber logs. Do not handle these logs
with your bare hands.
always wear gloves to prevent skin irritation from ceramic fibers.
After
handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
LG639
DV6000 right log
Figure 42 -
Install Right Log (#2)
Right Log
(#2)
Pins
Control Panel
w
a
RNING
The positioning of the logs is critical to the safe and clean
operation of this heater. Excessive sooting and other problems
may result if the logs are not properly and firmly positioned in the
appliance. Never add additional logs or embellishments such as
pine cones or vermiculite to the heater. only use the logs supplied
with the unit.
Failure to position the parts in accordance with diagrams below or
to use only parts specifically approved for this heater may result
in property damage or personal injury.
LG638
DV6000 left log
Figure 41 -
Install Left Log (#1)
Left Log
(#1)
Grate
Pins
Control Panel
LG638
