56D3049
69
TROUBLESHOOTING REMOTE SYSTEM
SYMPTOM
POSSIBLE
CAUSE
ACTION
1. Battery icon on LCD on transmitter. 1. Low Battery
1. Replace batteries. Change batteries every 6 months.
2. LCD display is blank
2. Check battery installation or replace batteries.
3. LCD display shows “funny” display
3. Press Reset button at the back of the transmitter.
4. Appliance does not come on.
1. Wiring / Electrical
Connections
1. Slide the switch to ON, if appliance comes ON, wiring is not
the cause.
2. If appliance does not come on,
2. Privacy (DIP)
switch setting on
transmitter does
not match receiver
1. Make sure the transmitter and receiver have the same DIP
switch settings.
3. Transmitter mea
-
sures temperature
exceeding 99°F
and shows “HI” on
LCD
1. Move transmitter to a cooler place and wait until temperature
drops below 99°F.
4. Distance between
the transmitter and
receiver is more
than 30 feet
1. Make sure the operating distance is less than 30 feet
5. Receiver cannot receive signal.
1. Receiver is
installed in an
enclosure
1. Make sure the receiver is not located inside to tight of an
enclosure.
6. Blower is not on after the fireplace
is turned on
1. Blower setting is
off
1. Press FAN key to select Fan speed you desire.
2. Blower delay set
-
ting is set too high
2. Press and hold FAN key to set desired ON/OFF delays. This
is done in minutes.
W
ARNING
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could
void the user’s authority to operate
the equipment.
TROUBLESHOOTING
