46
56D3049
ON
DIP
1 2 3 4
ON
DIP
1 2 3 4
ON
DIP
1 2 3 4
ON
DIP
1 2 3 4
OPERATING INSTRUCTIONS - REMOTE HI/LO WITH BLOWER
REMOTE TRANSMITTER
INSTALLING BATTERIES
The remote transmitter uses three (3) “AAA” batteries.
To install batteries…
1. Press down the battery door tab. Pull out to remove the battery door.
2. Install the batteries as indicated on transmitter.
3. Close the battery door and snap in place.
4. When three batteries are installed, the transmitter will initialize for 10 seconds and then is ready for use.
5. The batteries should be replaced at least once every 6 months or when the low battery icon indicator is displayed.
SETTING PRIVACY (DIP) SWITCH ON RECEIVER AND TRANSMITTER:
The remote receiver and transmitter privacy (DIP) switches are preset at the factory. In the event of activation
or interference from other nearby transmissions, reset the code using the following procedure:
1. Slide the code switches on the transmitter and receiver to your choice of ON or OFF position. Switches #1, #2, #3
and #4 are preset to “ON” for both the transmitter and receiver.
2. The switches on the transmitter and receiver must match in order for the system to work.
3. To check, press either the On or Off button on the transmitter and the receiver indicator light will blink. If not repeat
step 2.
4. The system is now ready to operate.
NOTE:
See optional 6-hour shutdown on page 49.
Transmitter
Receiver
Dip Switches
Figure 67 - Dip Switch Set at Default
W
ARNING
Do not use two (2) or more remote control systems in the same area with the same
dip switch settings, as they will communicate with each other. This may cause the
appliances to malfunction.
Continued
