530501
18 24 30VL
cover
The design of this appliance complies with Standard Z21.11.2 of the American National Standards Institute
and is so certified by the International Approval Service.
In accordance with Standard Z21.11.2, this appliance may be operated as an unvented heater when installed
in a solid-fuel burning fireplace with the flue damper closed or an ANSI approved ventless firebox enclosure.
Follow the applicable instructions contained in this manual. (State or Local Codes may only allow operation of
this appliance in a vented configuration. Check your state or local codes.)
READ AND SAVE THESE INSTRUCTIONS
Unvented Gas Log
Heater
Installation and Operating
Instructions
This is an unvented gas-fired
heater. It uses air (oxygen)
from the room in which it is
installed. Provisions for adequate
combustion and ventilation air
must be provided.
Refer to page 7.
WARNINGS
If the information in this manual is not followed exactly,
a fire or explosion may result causing property damage,
personal injury or loss of life.
– Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
– WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
– Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
This appliance may be installed
in an aftermarket, permanently
located, manufactured (mobile)
home, where not prohibited by
local codes.
This appliance is only for use
with the type of gas indicated on
the rating plate. This appliance is
not convertible for use with other
gases.
MODELS: 18VL, 24VL and 30VL
Natural Gas or Propane/LPG
Control Type: Millivolt
53D0501 7/09 Rev. 7
