33D4051
11
VFS & DBX Series Vent Free Fireplaces
FIREPLACE INSTALLATION
SECURING HEATER TO FLOOR OR HEARTH
NOTE:
Clearance requirements as detailed in
“CLEARANCES and HEIGHt REquIREmENtS”
section on
Page 15
of this manual, must be met before securing the heater in place.
To prevent movement, the heater must be secured to the floor or hearth.
1. Open the control access door and remove the screen.
. Remove carton containing the four-log set.
3. To remove the grate and base assembly, take out two () screws as shown in
Figure 8
.
4. Lift grate and base assembly out of the firebox.
5. Secure the firebox with two anchoring screws (3/16" x 1
Z\v
" length) supplied with the fireplace
system.
Figure 9
NOTE:
If the unit is mounted on carpeting, tile or combustible material without the hearth, a metal
or wooden base covering the entire width and depth of the base must be installed.
FP2515
remove grate
Screws
Grate
FP515
Figure 8 -
Remove Grate
FP2516
secure base
Anchor Screws
3/16" x 1
Z\v
"
FP516
Figure 9 -
Secure Heater to Floor or Hearth