6
majacraft
Slide the pulley onto the flyer shaft. Align the grub
screw over the flat on the flyer shaft. Then use the
2mm allen key to tighten the grub screw and secure
the whorl on to the flyer shaft.
5. Pulley on to Flyer Shaft
Required:
Pulley
2mm allen key
(in the hardware bag)
Slide the 10mm stem pin that is glued into the head assembly
down into the hole at the top of the stem.
4b
4c
5a
5b
5c
5d
Screw the wooden hex lock bolt
into the hole on the side of the
stem to lock the head into place.
Find the small flat ground on the flyer, it will be near
the bearing on the head. Turn the flyer shaft so the
flat is on top.
