majacraft
7
Place the spinning head behind the upright with the flyer shaft facing to the front and the white nylon
guides on the head located inside the handle slot. Slide the coujntersink bolt and washer through the slot in
the handle and tighten it carefully. You can read the additional instructions at the end of this document for
information on setting the bobbin drive band tension.
The spinning head can be raised or lowered to suit the tensioning of
the drive belts and the height you wish to spin at. The recommended
approximate position is the silver bolt positioned half way up the slot.
6. Spinning Head
Required:
1 M6 45mm (1 3/4”) Silver countersink bolt
(in the hardware bag)
4mm allen T wrench
(in the hardware bag)
1 Large SIlver aluminium handle washer
(in the hardware bag)
Spinning Head
1 M6 Wooden Adjuster Screw
(in the hardware bag)
The 6mm wooden adjuster
screw can be screwed
into the end of the hinged
adjuster block now.
6a
6b
6c
6d
5e
Slide the flyer drive pulley onto the flyer shaft and align
the threaded hole over the flat ground on the shaft.
Screw the short grub screw into the threaded hole with
your 2mm allen key and secure the pulley to the head.
Tighten the grub screw firmly. Failing to line the grub
screw up with the flat on the shaft will cause the pulley
to slip on the shaft producing issues with take up of the
yarn when spinning.
5f
