majacraft
5
Fit the drive wheel to the base assembly. Slide the drive shaft through the black bushes in the Stem/Handle
assembly from the back to the front. Screw the wooden nut on to the drive axle and tighten it firmly.
Fit the pedals using the twelve gold 25mm screws provided.
Match the holes in the hinges with the holes at the front of
the base. The long side of each pedal goes nearest to the
central base.
We recommend you insert the two screws in the hinge
holes closest to the outside edge of pedal. This keeps
the pedal still and aligned while you put in the remaining
screws.
Required:
Drive Wheel assembly
1 - Star Washer
(in the hardware bag)
1 - Wooden Nut
(wrapped separately)
4. Drive Wheel
Make sure the wooden nut has been removed from the drive axle. Check that the star washer is on the drive
axle - if not, then slide the star washer on. The black bushes must be in place on the front and back of the
Stem/Handle assembly
3b
3c
4a
4b
4c
4d
