MISCOM8220G Layer 3 Din-rail Industrial Ethernet Switch
- 11 -
transmitted in a line to determine which lines should be separated. The rule
of thumb is that wires with the same electrical characteristics can be bundled
together. Separate the input and output lines. It is highly recommended that
all equipment lines in the system be labeled when necessary.
The switch should be connected to the protection ground:
Grounding and wiring can effectively suppress the effects of noise
caused by electromagnetic interference. A ground connection should be
made before connecting the device, from the ground screw to the grounded
surface.
2.2.2. Host installation
The schematic diagram of the whole machine is shown in Figure 2-6.
Figure 2-6 Schematic diagram of the whole machine
For most industrial applications, it is very convenient to install the rails.
The installation of the rack should be checked before installation, mainly
including the following two contents:
Is there enough room for installing this product?
Is there a power supply suitable for the work of this product?
When installing, first determine the installation location of the product, then
fix it with the rail.
2.2.3. Cable connection
After the correct installation, the cable can be installed and connected,
mainly including the cable connection of the following interfaces.
Fiber and Ethernet port
The Gigabit Tx port of the terminal equipment is 10/100/1000M. Connect
to the terminal device using a straight-through cable and connect to the
network device using a crossover cable.
