MISCOM7212GP Series Industrial Gigabit POE Switch
- 7 -
After the SFP module hot-plug
Heat pull handle when the position
2.1.7. Ethernet RJ45 Port
This product has multiple RJ45 10/100/1000Base-T Ethernet ports. Each
RJ45 port with auto-negotiation, auto MDI / MDI-X connection. Internet can be
used straight line/ cross-over cable to connect the switch to terminal equipment,
servers, hubs or other switches. Each port supports IEEE802.3x adaptive, so
the optimum transmission mode (half or full duplex) and data rate (10Mbps or
100Mbps) can be automatically selected (the connected devices must also
support this feature). If the device is connected to these ports do not support
adaptive, then the port will send the correct speed, but will default to half
duplex transmission mode.
Each RJ45 port supports 802.3af/at standard, single port maximum output
30W.
2.2. Hardware Installation
2.2.1. Installation Notice
The Industrial Ethernet switch is used standard 35mm DIN-Rail
install.Please make sure a suitable work environment, including power
requirements, enough space, connect equipment and other equipment status.
Please confirm the following installation requirements:
Power supply: according to the power marked on the product label.
Environmental requirements: Temperature -40°C~ 85°C, relative
humidity 0~95% (no condensation).
Grounding resistance requirement: <.
5
Configuration requirements under the contract, check the cable is in