S12800 Routing Switch Installa
tion Manual V1.0
Maipu Confidential & Proprietary Information
Page 49
Figure 4-17 Remove the dust cap of the fiber
Step 3:
Remove the dust plug of the SFP module, as shown in Figure 4-18.
Figure 4-18 Remove the dust plug of the SFP module
Step 4:
Insert the prepared fibers to the ports of the optical module in order, as shown
in Figure 4-192.
Figure 4-19 Connect the fiber
Step 5:
Connect the other side of the fiber to the peer device.
When using the uni-directional dual fiber to connect the optical module, pay attention to
make the receiving and sending signals of the modules at the two sides cross-connected.
If the fiber connector ferrule has dust, please use the air-laid paper to stick the absolute
alcohol and clean the face of the fiber connector ferrule.
4.2.3 Access Network via MPO Fiber
For the MPO QSFP+ optical interface of the switch, you can use the MPO fiber to connect the
network. Before connecting fiber, first install the optical module to the switch and then insert
