INSTRUCTION MANUAL FOR DISHWASHERS
Page 6 of 20
MDI TT28-26 - 02
UK
1.6
FIRST START-UP AND SETTING OF DETERGENT DOSING SYSTEM
(
FOR MACHINES WITH DETERGENT ELECTRODISPENSERS
)
To achieve a good washing result, detergent and rinse aid dosage shall be adjusted based on the
concentrations specified by the manufacturer of the detergent/rinse aid used.
Furthermore, a first activation is required so as to fill up the intake and delivery hoses of detergent dispensers
Electrodispenser Activation
Refer to section 4.4 “ADJUSTMENTS AND SETTINGS”, then access the parameter setup menu, shift to
“detergent pump”, and keep button 4 (fig. 1) pressed: electrodispenser will be steadily activated; keep it
enabled until the intake ducts are full.
Then repeat the same procedure for the rinse aid electrodispenser, selecting “Rinse aid pump” menu option.
Concentration Adjustment
Go to “Dosage Detergent g/l”, and increase or decreases the desired concentration using buttons 3 and 4 (fig.
1). The set concentration and the electrodispenser activation time (in seconds) are shown on the display.
Repeat the same procedure for the rinse aid electrodispenser, selecting the “Dosage rinse aid adjustment”
menu option.
1.7
CONNECTING DETERGENT LEVEL SENSORS INSIDE TANKS
This dishwasher model features special connectors for detergent level sensors inside tank.
These connectors are positioned on the rear side, at the bottom.
For connection, proceed as follows:
- Remove jumper connector
- Connect sensor pin: respect the “Detergent” and “Rinse Aid” symbols
- Insert special sensors inside tanks.
Machine will signal that no detergents are available through the messages specified in section 3
“DISHWASHER USE”.