Maidaid Halcyon D3121, User'S Installation Manual

Page: 12 / 17

INSTRUCTION MANUAL FOR DISHWASHERS
Page 9 of 14
UK
4.7 Automatic cycle start-up
This function is used to make the chosen cycle start automatically when the door is closed. To enable,
proceed as follows (
Fig.6
):

If not made available by default, the function must first be enabled via the settings menu.

With the appliance on and the door open, press and hold (for at least five seconds) START (4) until
AS appears on the display .

To disable the function, with the door open press START (4) again for five seconds.
4.8 Removing the integral filter

Move the washing and rinsing arms at right angles to the edge of the door (
Fig.7
).

Lift each semi-filter by the relative handle.
4.9 Emptying the dishwasher
4.9.1 Appliances with no drain pump

Switch the dishwasher off.

Remove the integral filter (
Fig.7A
).

Pull up and remove the overflow pipe (
Fig.8B
).

Wait for the tub to empty completely.

If necessary, extract the tub filter and clean (
Fig.8C
).
4.9.2 Appliances with drain cycle (*optional)

If present, remove the integral filter (
Fig.7
).

If present, remove the overflow by pulling upwards (
Fig. 9
).

Close the door.

Select the cycle dr

Press START (4) to start the cycle.

The machine runs a drain cycle with self-cleaning (*where foreseen) and then switches off.

If necessary, extract the tub filter and clean (
Fig.8C
).
4.10 Turning the dishwasher off

Press ON/OFF (1) , on the DISPLAY (5) the central segments will light up, indicating that the
machine is powered.
4.11 Resin regeneration (*optional)
I
n machines fitted with water softener, when the warning ‘SALt’ appears you should add salt to the
relative container; proceed as follows:

Remove the basket from the machine.

Remove the integral filter (
Fig. 7
).

Unscrew the cap on the salt container (
Fig. 11
).

Pour in approx. 700g of large-grain kitchen salt, using the funnel supplied. (when filling for the first
time, fill the tank firstly with water)

Close the container firmly.

Rinse the area around the salt cap by hand and run a self-cleaning cycle to avoid any risk of
corrosion.

The ‘SALt’ warning will disappear after a few minutes.
The warning
rEG on the display indicates that the machine is running a resin regeneration cycle,
needed to ensure the correct operation of the water softener; while this warning is shown, the cycles
run could be longer than usual.
N.B. Do not switch off the machine if a regeneration cycle is underway