INSTRUCTION MANUAL FOR DISHWASHERS
Page 6 of 12
UK
Chap 4
USING THE MACHINE
4.1
Key and symbols
Referring to
Fig.1
:
1 ON/OFF
BUTTON
4
INFORMATION
DISPLAY
2 PROGRAMME SELECTION
BUTTON
5 STATUS BAR
(LED)
3 START
BUTTON
4.2
Switching the dishwasher on
Referring to
Fig.2
:
•
Turn on the main power switch and open the external water tap.
•
Check the presence of the overflow, where foreseen.
•
Press
ON/OFF (1)
.
•
Loading begins automatically when the machine is switched on.
•
The orange light on the
STATE BAR (5)
runs downwards and the point on the display flashes until
the machine has completely filled.
•
When the working temperature is reached, the
STATUS BAR (5)
stays on, lit in green as shown in
the figure.
•
The optimal wash conditions have been reached
•
In the event of a fault, the led bar flashes red and stops the machine operation; a minor error is
indicated in orange, and will not stop the machine cycle.
4.3
Filling the rack
Referring to
Fig. 3
,
to ensure the correct operation of the dishwasher follow the rules described below:
•
Use a suitable rack, fill without overloading and without overlapping the dishes.
•
Always wipe the dishes before placing in the dishwasher; do not put dishes with dry or solid
residues in the washer.
•
Place the empty dishes in the rack facing downwards.
•
Place plates and the like in the sloping rack, with the inner surface facing upwards.
•
Place the cutlery in the cutlery basket, handle end down.
•
Do not place silver and stainless steel cutlery in the same cutlery basket as this will turn the silver
brown and may corrode the steel.
•
Wash the dishes immediately after use, in order to prevent any residue from hardening and sticking
on them.
•
Use only solid, dishwasher-proof dishes.
4.4
Cycle selection and start-up
•
Press the
PROGRAMME SELECTION
button (2) repeatedly to select a wash cycle that is suitable
for the dishes to be washed; the display will show the cycle number chosen
(Fig. 4)
.
•
To run the programme, press
START (3)
; the
STATUS BAR (5)
starts to flash orange, increasing
from the bottom upwards to indicate the progression of the cycle.
•
When the cycle is over,
Ed
appears on the display to indicate the end of the cycle.
•
For rapid drying, remove the rack from the machine as soon as the cycle finishes.
•
To stop a wash cycle early, press
START (3)
.
N.B. In hood versions, after the first work cycle the automatic start is automatically enabled; the
subsequent cycles will be enabled automatically when the hood is closed. This operating mode
is marked on the display by “AS”.
