UK │ 11. Mounting
8
NOTICE
Danger of short-circuits caused by damp
if the connection cable is not inserted in
the housing correctly.
Ensure that the rubber seals on the PG
screw connections tightly surround the
cables.
7. Feed the mains power cable through the
PG screw connection [6] and the
temperature sensor connection cable
through the PG screw connection [7] into
the housing. Secure the connection cables
with the PG screw connections (the rubber
seals on the PG screw connections must
surround the cables tightly).
8. Connect up the connection cables
as shown in the wiring diagram (
Chapter 16). Check the wiring and if
necessary, tighten the screws in the
connection terminals.
9. Remount the cover [10] (4 screws) and
refit the rotary knob [11]. Make sure that
the rotary knob shaft [4] is not damaged
and that the rubber seal fits tightly round
the shaft.
10. Install the fan(s) in accordance with their
operating instructions.
12. Start-up
1. Check that the technical data has been
adhered to
rating plate.
2. Switch the mains fuse on. Set the setpoint
temperature using the rotary knob [11].
3. Run function test.
13. Cleaning
Clean the housing and the temperature
sensor regularly using a dry cloth.
14. Fault rectification
Fault rectification should only be carried
out by a trained electrician.
Check the relay switching state before fault
rectification: LED [2] lights up if the relay is
energised (terminals 4 and 5 closed).
15. Disassembly and disposal
Dismantling should only be carried out by
a trained electrician.
The unit and the packaging contain parts that
can be recycled, and should not end up in the
domestic waste.
Dispose of the packaging material in an
environmentally-friendly way, in compliance
with the regulations valid in the country where
you are.
At the end of its service life, dispose of the
unit in an environmentally-friendly way, in
compliance with the regulations valid in the
country of use.
16. Wiring diagram
TH 10 combined with fan
Terminal 3 Cooling
Terminal 4 Heating
F
Temperature sensor
M
Fan
S1
Jumper:
K: Cooling / H: Heating
