Mahlkonig X54, Original Instructions Manual

Page: 29 / 60

29
Home Grinder X54
The two pins on the back of the module slide into the
holes in the module area.
The portafilter switch in the module area slides
smoothly into the portafilter switch cover of the
module.
3. Release the pushbutton.
The pins on the back of the module engage in the
module area and lock the module in the correct
position.
Removing the container module
1. Press and hold down the pushbutton on the side (7)
to remove the module (21) .
This is how the locking of the module is released.
2. Carefully remove the module from the module area
(11) towards the front.
Be careful not to tilt the module when pulling it out
of the module area: The portafilter switch (12) must
slide smoothly out of the portafilter switch cover (22)
in the module.
Adjusting the portafilter module
To ensure that your portafilter (24) is optimally
seated in the portafilter module (18) , you need
to set the portafilter support (20) to a suitable
height for your portafilter. Make this adjust-
ment before inserting the portafilter module.
1. Use a screwdriver to undo the screw (23) of the
portafilter support on the back of the module by
turning it anti-clockwise (see Fig. G ).