2
Mahlkönig X54 home grinder FAQ part 2 (general)
Which functions are included in the X54 software?
§
4 preconfigured grinding-by-time recipes (2 for espresso (single/double); 2 for filter (single cup & litre))
§
Adjustable to user preferences
§
Manual on-demand grinding
§
Sleep timer
§
Disc lifetime monitor
§
Security switch off of the motor when bean hopper is not mounted
§
WiFi for usage statistics and error logs (for service technicians)
§
See operating instructions
Where is the X54’s ON/OFF switch?
§
The X54 ON/OFF switch is located at the back of the grinder where the power cable exits the housing
§
The X54 takes approximately 3-5 seconds to fully boot
The display of my X54 is on, the motor does not start. What can I do?
§
If the Error message E001 is displayed the motor does not start because the bean hopper is not mounted correctly
§
The hopper has to click-in completely for the motor to start operating. To mount correctly, push down the bean hopper and push through the stainless steel bean slider
until the hopper is locked into place
§
When new, the hopper fixation will be a bit tight, which will wear down after some repetitions
Which repairs may I carry out without loosing warranty?
§
As described in the user manual, the grind chamber may be opened for cleaning or checking for foreign objects
IMPORTANT: Any warranty claim is void in any of the following cases:
1. The grinder casing was removed
2. Electronic components were changed or tampered with
3. The grinder was obviously manipulated or changed
4. Improper use (other materials than coffee were ground).
How and how often should I clean my grinder?
§
Your grinder should be cleaned approx. once a week. Cleaning intervals are highly dependent on intensity of use, type of beans and grinding degree
§
We recommend GRINDZ to clean your grinder – please follow the user manual for specific directions
How do I empty my grinder to switch coffee beans
§
Pull out the bean hopper slider until the indication marking is visible – “closing” the hopper while leaving it firmly attached. Now operate the grinder normally until all
residual beans in the grinder neck have been consumed. You can now pull out the bean hopper slider completely to remove the hopper and switch beans.
