PROFESSIONAL GRINDER
26
Fault
Cause
Remedy
• The grind is too
fi
ne.
Set the grind to “10” and
start the grinding process.
The grinder clears itself.
Then put the grind se ng
back to the grind you
require while the grinder is
running. If the problem is not
resolved, consult your dealer
at the address given in the
“
Service
”
sec on.
• A foreign object is
in the burr.
Clean the burr as described
in the “Cleaning” sec on and
remove the foreign object
as you do so. If the foreign
object cannot be removed in
this way, consult your dealer
at the address given in the
“
Service
”
sec on.
The grinder
does not grind,
the display is
illuminated,
the grinding
mode has been
preselected.
• The
grinding me
is set to 0.
• The
maximum
permi ed
opera ng
cycle has been
exceeded.
Reset the grinding me.
If necessary, switch the
ven la on to AUTO and wait
un l the ven la on switches
o
ff
automa cally at 82 °F
(28 °C).
The grinder does
not start up, the
display is not
illuminated.
• The power plug is
not plugged into
the socket.
Insert the plug into a correctly
installed socket.
