20
Double espresso GrinDer
Operation
INFORMATION!
Danger of overheating!
Exceeding the maximum permissible operating cycle can cause the
grinder to overheat.
– Do not exceed the maximum operating cycle
(see chapter “Technical data”).
– Observe the recommended pause when the maximum permis-
sible operating cycle is reached (see chapter
“
Technical data
”
).
• The grinder has two fuses that act as an overcurrent
protection device. If this overcurrent protection device is
triggered because of electric overload, the grinder’s circuit is
interrupted.
• To be able to operate the grinder once again after triggering
the overcurrent protection device, switch the On/Off switch
(21)
to “0” (off) and contact an authorized service partner
(see chapter “Service”).
• The grinder also has a motor protector, which switches off the
grinder when the motor becomes too hot. As soon as the
motor has cooled down, the grinder can be put into operation
again (see chapter: “Troubleshooting”).
Adding coffee beans
1. Remove the lid from the bean container
(1)
.
2. Pour whole roasted coffee beans into the bean container from above.
• The maximum filling quantity should be approx. 1 cm below
the edge of the bean container.
• The minimum filling quantity should not fall below 2 cm in
order to ensure that there are no dosing fluctuations.
3. Place the lid back onto the bean container.
4. If necessary, open the bean container by pulling out the sliding valve
(15)
(see
Fig. G
).
Summary of Contents for K30 Competition
