S P E Z I A L M Ü H L E N | S P E C I A L G R I N D E R
6. Now the grater basket and the pressure disc can be replaced where-
by the side of the pressure disc which has been exposed when turn-
ing must be pressed against the grater basket. Now the hexagon
screw can be screwed in together with the washer.
7. To tighten the hexagonal screw position the holder on the right
hand guide rod and let it engage into the groove on the grater bas-
ket.
8. Tighten the hexagonal screw well.
9. Remove the holder.
10. Replace the grater casing and the cover with feeder tube and the
two star handles and tighten well.
12. Push drawer into its holder and connect the machine to the mains
supply again. Now you can use the device again.
hexagonal screw
10. Grinding Disc Replacement
If the grinding performance decreases and the ground products are hot
and irregular, you should change the grinding discs.
1. Take the grinder apart as described under “9” and remove the
grinding discs from the grinder casing and the pre-breaker
using a screwdriver.
2. Clean the surfaces of the new grinding discs thoroughly and
screw them in position tightly and evenly.
3. Close the grinder casing again as described under “9” and set
the grind degree again as described under “8”.
11. Exchanging the Grater Basket
1. Take the grater apart as described in “9.4”.
2. Push the enclosed holder with the drilled hole on the left guide rod
for the grater housing and place in the groove of the grater basket
holder (the angled side of the holder is positioned on the basket
holder).
3. Now, using a 13 mm socket spanner you can unscrew the hexago-
nal screw in the middle of the grater basket by turning it to the left.
4. Now remove the old grater basket and remove the pressure disc.
5. Clean the surfaces of the new grater basket and the grater basket
holder well
13
