BLEEDING FUEL SYSTEM
MAINTENANCE
PROCEDURE OF BLEEDING AIR FROM FUEL SYSTEM
Air must be removed :
1) When the fuel filter or lines are removed.
2) When water is drained from fuel filter.
3) When tank is completely empty.
4) When tractor is not used for a long period of time
Make sure that fuel
Pipe clips are
tighten.
Open the air vent
on the fuel injection
Pump.
Pump the fuel pump
knob located on the top
of the fuel filter.
The fuel pump knob will
pump easily at first and
with added resistance
as air is purged from the
system.
To make sure air is com
-
pletely purged, pinch
the fuel over flow hose
with fingers if a pulsa
-
tion is left when the
knob is pumped then,
no air remain
(1) Set the hand throttle lever / accelerator at maximum
speed position.
(2) Turn on the key switch to start the engine and then
reset the throttle at the mid speed position.
If engine doesn’t start try it several times with 30 seconds
Intervals
Accelerate the engine to remove the small position of air
in the fuel system.
If the air still remains and the engine stops, repeat the
above steps.
Close the air vent.
CAUTION :-
Do not hold key at engine start position for more than 10 seconds continuously. If more
engine cranking is needed try again after 30 seconds.
Always close the air vent screw except for bleeding fuel lines other wise, engine will run
irregularly or stall frequently.
⚠
20
Summary of Contents for Jivo 245 DI
