Mahindra BERSB60R, Owner'S Manual

Page: 9 / 32

6
ASSEMBLY
ASSEMBLY
Install rotation rings & the chute
STEP 1
SNOWBLOWER PREPARATION:
Refer to parts breakdown section for parts identification.
Secure the rotation ring & chute together.
Figure A
Loosen the tensioner (item 1) of the hydraulic motor.
Install the metal rotation ring (item 2) over the
opening of the chute as shown.
Install the nylon rotation ring (item 3) over the
opening of the chute as shown.
Place the chute (item 4) facing the rear of blower on
the opening as shown.
Clip the back under the rotation ring and turn the
chute towards the front to lock into place.
IMPORTANT: Make sure to place the holes of the
metal rotation ring (item 1) in line with the holes at the
base of the chute (item 2) as shown in Figure A.
Insert the four spacers (item 3) between the metal
rotation ring and the chute as shown.
Insert the four carriage bolts 1/4’’ x 1’’ (item 4) from
the bottom of the rotation ring as shown.
Secure in place with four nylon insert lock nuts
1/4’’ (item 5) as shown.
Turn the chute towards the front as shown in figure A.
Loosen the two bolts (item 6) to adjust the rotation
motor’s sprocket into the teeth of the metal rotation
ring.
Use the adjustment bolts (item 7) to make sure the
motor sprocket rests lightly inside the metal rotation
ring.
Tighten bolts. Lock the bolts (item 7) with the nuts.
IMPORTANT: Do not over tighten the adjustment
bolts (item 7). Tightening the bolts too much may
damage the rotation ring.