Mahindra BERSB60R, Owner'S Manual

Page: 10 / 32

7
ASSEMBLY
ASSEMBLY
Install half drive line
Install the P.T.O. drive mechanism (item 1) from
separate kit, into the snowblower’s driveline (item 2)
by aligning the stamped marks (item 3) (located
between the splines at the end of the shaft) with the
large groove (item 4) in the hollow tube on the
snowblower’s section.
Only one position allows the sections to be inserted
one into the other.
Install the P.T.O. drive mechanism
STEP 2
SNOWBLOWER INSTALLATION:
NOTE: Lower the parking stand (item 1) with your
foot.
Turn the snowblower face down. Take care to avoid
being pinched by the parking stand.
Insert the key (item 2) in the half drive line (item 3) as
shown.
Insert the half drive line on the input shaft (item 4)
and align the holes together as shown.
Insert the hex bolt 1/4’’ x 2’’ (item 5) as shown and
secure with a nylon insert lock nut 1/4’’ (item 6).
Tighten the set screw (item 7) to hold the key in
place.
Turn the snowblower back on the parking stand.
Install the appropriate hydraulic connectors on the
hydraulic hoses. Follow the instructions included with
the adaptor kits.
#700643 on the Max 22-24-25
#700644 on the Max 26-28
For OJA follow instruction into the subframe manual
Drive the vehicle forward towards the accessory and
unite them by raising the lift arms (item 1).
Leave the accessory on the ground.
Stop the vehicle’s engine.
Secure the accessory to the subframe with two pins
(item 2) and two lynch pins (item 3).
Unite accessory and subframe
WARNING
Stop the engine.
Place a block of wood under the subframe when
installing the pins to limit any movement of the
subframe during installation.
If you do not put a block of wood you could be
pinched if the hydraulic malfunctions.