8
LEVELING THE REAR BLADE
Manually adjust one of the two lower lift arms up or
down to level the implement from left to right.
Manually adjust the length of the top
-
link to level the
implement from front to rear.
Ensure that the lower lift arms are blocked to prevent
excessive movement.
CHECK INTERFERENCE
If required, offset blade to desired setting. Refer to
“
Blade Offset
” in the Adjustment section for
instructions.
If required, tilt end of blade to desired setting. Refer to
“
Blade Tilt
” in the Adjustment section for instructions
Raise blade off the ground and angle blade as far as
possible towards the right rear tractor tire. Refer to
“
Blade Angling
” in the Adjustment section for
instructions.
Return to the tractor and slowly raise 3
-
point lift arms
fully up and down to make sure blade does not make
contact with tractor tire, drawbar, and any other
equipment on the tractor.
-
Move or remove drawbar if it interferes with blade.
-
Set tractor control lever stop to restrict lifting height if
blade interferes with tractor tire.
Do the same, but angle blade as far as
possible towards the left rear tractor tire.
ASSEMBLY
Summary of Contents for BBLST5
