Mahindra AX AC 4S ST, Owner'S Manual, Page: 280 / 337

© Copyright Mahindra and Mahindra Ltd. 112020
15-15
the corresponding position tyres sensor needs to be checked by
carefully opening the tyre
• If the sensor is found to be damaged then it should be replaced
with a new one and manual learning should be done
S Se en ns so orr F Fa au ullttyy/ / L Lo ow w B Ba atttte erryy A Alle errtt
The Tiretronics sensor in the vehicle tyres has an internal individual
battery to each sensor fixed. If the battery level is too low or the
sensor by itself is malfunctioning then the Tiretronics system shall
give this alert.
• If the Tiretronics sensor low battery/faulty is set then the
corresponding position tyres sensor needs to be removed by
carefully opening the tyre and replacing it with a new sensor
• Post replacing the new sensor, manual learning should be done
1 15 5..6 6..6 6 T Tiirre ettrro on niic css L Le ea arrn niin ng g
After tyre rotation or Tiretronics sensor replacement, the receiver
must be learnt, else the Tiretronics warning lamp indicates a
malfunction.
M Ma an nd da atte e P Po oiin nttss
Manual learning is the process by which the identities of 5 sensors
installed inside the tyres are learnt and programmed in to the
memory of the receiver module.
1.
Manual learning should be compulsorily performed on any of
the following conditions or operations done
• Any sensors replaced.
• Any of the tyres are replaced
• If any of the tyres or set of tyres are shuffled or swapped in
position
• If tyre rotation operation is performed
• If it is observed that the alert indications in the tiretronics
screen are not co-relating with respect to their actual
position in the vehicle
2.
Once manual learning is initiated, the sensors inside the tyres
need to be triggered by leaking the air from each tyre one at a
time and should be completed within certain value post to each
event for learning all 5 tyres
3.
Do not perform Manual learning process at the same time on
two vehicles with in the radius of 20 meters
4.
It is mandatory that manual learning of tyres should follow the
sequence of ‘front left tyre position, front right tyre, rear right
tyre, rear left tyre and spare tyre’
5.
It is required to ensure the tyres have pressure > 32psi and <
36psi before initiating the manual learning process
6.
Post manual learning, all tyres should be filled to the placard
pressure value
W WH HE EE EL LS S A AN ND D T TY YR RE ES S