c-MIG 2800 / 3300
17
EN
6.
Error codes
The machine has several protection mechanisms to protect machine against damage.
Activating of any protection is indicated on the display as error with code.
Over temperature error
– machine is overheated, time of make exceeds
Let machine be cooled, do not switch the main switch off before fan will stop!
Over current error
– there is too high welding current detected.
Machine must be switched off by main switch. After turning on back again, Power
setup should be reduced to not exceed maximum current of the machine.
7.
CARE AND MAINTENANCE
Pull out the power cable from the socket before every maintenance and troubleshooting. The
device is almost maintenancefree.
It is necessary to check feeding wheel, pressure roller and inflow nozzle regularly, if there is
not some dirt. If it is, you have to clean it out.
Please, change the contact tip on the torch regulary
The complete set of pressure hoses should be cleaned up from time to time, because of em-
bedded dust and parts.
The contact nozzle of the torch is wearing up subsequently. When the hole in the nozzle is
too large, it is necessary to change the nozzle. The metal drops are embedding in the inner
walls of the torch cover. Take them out if necessary. The separator is helpful and it is also
a prevention against the firm caking of the drops.
You have to change the damaged cables at once.
7.1.
Disposal of the machine
Do not Do not dispose of electrical equipment together with the normal
waste!
In observance of European Directive 2002/96/EC on Waste Electrical
and Electronic Equipment and its implementation in accordance with
national law, electrical equipment that has reached end of its life must be
collected separately and returned to an environmentally compatible
recycling facility.
