Magtrol 6530, User Manual

Page: 67 / 83

57
Magtrol Model 6530 Three-Phase Power Analyzer Chapter 7 – Optional Features
OPTIONS
e d o C d n a m m o C n o i t c n u F n o i t a n a l p x E
> r o t a n i m r e t < m M C
r o f e d o m n o i t a r b il a c s t e S
A / D t u p t u o g o l a n a
. s l e n n a h c
. N O / F F O e d o m n o i t a r b il a c s e t a c i d n i " m "
: e r a m r o f s e u l a V
F F O e d o m n o i t a r b il a c A / D = 0
) e d o m t u p t u o l a m r o n (
s l e n n a h c t u p t u o A / D ll a t e S = 1
. e l a c S ll u F e v i t i s o P o t
) l a n i m o n V 0 1 + (
s l e n n a h c t u p t u o A / D ll a t e S = 2
. e l a c S ll u F e v i t a g e N o t
) l a n i m o n V 0 1 - (
> r o t a n i m r e t < 2 m , 1 m G C
t u p t u o A / D s e t a r b il a C
. n i a g l e n n a h c
. ) 2 1 - 1 ( l e n n a h c A / D s e t a c i d n i " 1 m "
l e n n a h c A / D d e r u s a e m e h t s e t a c i d n i " 2 m "
ll u f e v i t a g e n r o e v i t i s o p ( e g a t l o v t u p t u o
. ) e d o m n o i t a r b il a c n o g n i d n e p e d e l a c s
> r o t a n i m r e t < X C
g o l a n a A / D ll a s e v a S
o t s e u l a v n o i t a r b il a c t u p t u o
. M O R P E E
- - -
7.1.5.4 Basic Calibration Process
1. Turn on the unit with SHIFT button pressed.
2. Send CM1 command. This sets all DAC outputs to 10 volts nominal.
3. Using a volt meter, measure the voltage on the channel.
4. Send the appropriate CG command. See Section 7.1.5.3 – Calibration Commands .
5. Repeat steps 3 and 4 until all 12 channels are complete.
6. Send CM2 command. This sets all DAC outputs to -10 volts nominal.
7. Using a volt meter, measure the voltage on the channel.
8. Send the appropriate CG command. See Section 7.1.5.3 – Calibration Commands .
9. Repeat steps 7 and 8 until all 12 channels are complete.
10. Send CX command to save calibration values.