6 - Magnetic Stripe Card Data Sent from Device to Host (MSR Only | Keypad Entry Only)
eDynamo| Secure Card Reader Authenticator | Programmer’s Manual (COMMANDS)
Page 41 of 245 (
D998200115-17
)
6.2
Track 1 Decode Status (HID | TLV | GATT | SLIP)
This one-byte value indicates the status of decoding Track 1. If bit 0 is OFF, no error occurred. If bit 0 is
ON, the device found non-noise data that was not decodable, and the device reports the track data length
is zero and does not provide valid track data to the host.
Format
Where to Find Value
HID
Usage 0x20
Streaming
N/A
TLV
Data Object 8262 Byte 1
GATT/SLIP
Offset 0
Bit
Position
7
6
5
4
3
2
1
0
Value
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Error
6.3
Track 2 Decode Status (HID | TLV | GATT | SLIP)
This one-byte value indicates the status of decoding Track 2. If bit 0 is OFF, no error occurred. If bit 0 is
ON, the device found non-noise data that was not decodable, and the device reports the track data length
is zero and does not provide valid track data to the host.
Format
Where to Find Value
HID
Usage 0x21
Streaming
N/A
TLV
Data Object 8262 Byte 2
GATT/SLIP
Offset 1
Bit Position
7
6
5
4
3
2
1
0
Value
Reserved Reserved Reserved Reserved Reserved Reserved Reserved Error
6.4
Track 3 Decode Status (HID | TLV | GATT | SLIP, 3-Track Only)
This one-byte value indicates the status of decoding Track 3. If bit 0 is OFF, no error occurred. If bit 0 is
ON, the device found non-noise data that was not decodable, and the device reports the track data length
is zero and does not provide valid track data to the host.
Format
Where to Find Value
HID
Usage 0x22
Streaming
N/A
TLV
Data Object 8262 Byte 3
GATT/SLIP
Offset 2