Magtek DynaProx, Installation And Operation Manual

Page: 38 / 56

6 - Operation
DynaFlex and DynaFlex Pro| Three-way Secure Card Reader Authenticators | Installation and Operation Manual
Page 38 of 56 ( D998200382-10 )
6.6.4 How to Power On / Wake Up from Standby Mode / Power Off
To power on the device, press and hold the pushbutton for one second, or connect the device to USB
power. After powering on, devices with touchscreens show a page of information about the device, then
transition to showing the
Welcome
page or custom graphics, if they are configured to do so. For more
information about custom graphics, see
D998200383 DynaFlex and DynaFlex Pro Programmer’s
Manual (COMMANDS) .
To power off the device, disconnect the device from USB power. After powering off, if the device is
connected to USB power, it immediately powers back on; if the device is battery powered, operators can
power it on the usual way (see section
6.6.4 How to Power On / Wake Up from Standby Mode /
Power Off ).
To reset the device, see section
6.6.5 How to Force Reset .
If all LEDs are off, the device is in Powered Off mode or USB Standby mode. For details about reading
the status of the device with LEDs, see section
6.1 About Operating Modes and section 6.3 About the
Status LEDs .
6.6.5 How to Force Reset
To force the device to reset, power it off then power it on again (see section 6.6.4 How to Power On /
Wake Up from Standby Mode / Power Off ). Alternatively, you may use a small tool such as a
paperclip to carefully press the recessed switch inside the small hole on the back of the device (see section
1.7 Major Components on page 14 ). The host may also reset the device by sending the Reset Device
command (see section 8 Developing Custom Software ).
The device also automatically powers off if the rechargeable battery reaches a level that is low enough
that the device may not be able to complete a transaction (see section
6.6.7 About Battery Warnings
and Automatic Reset ).
6.6.6 How to Turn Bluetooth LE Advertising On and Off
Reserved.