3 - Command Set
DynaPro Mini| PIN Encryption Device | Programmer’s Manual (Commands)
Page 54 of 128 (
D99875629-43
)
3.4.22
Command 0x1C - Set/Get Bluetooth LE Power Configuration (Bluetooth LE Only)
This command sets or gets the device’s Bluetooth LE power configuration, depending on whether it is
called in Set mode or Get mode.
Table 3-37 - Usage Table for Command 0x1C
Bit
7
6
5
4
3
2
1
0
Byte 0
0x1C (command identifier)
Byte 1
Reserved,
set to 0
Reserved,
set to 0
Reserved,
set to 0
Reserved,
set to 0
Reserved,
set to 0
Ready
Suspend
Power
down
Byte 2
Reserved, set to 0x00
Byte 3
Reserved, set to 0x00
Byte 4
Reserved, set to 0x00
Power Down bit: (Read/Write)
0: The device is not powered down.
1: The device is powered down.
Powering down the device will conserve power. The host will have limited communications capability
with the device when it is powered down. During this time, the device will only respond to command
0x1C. Powering the device down will conserve more power than suspending it. It takes more time to
power the device up than it does to take it out of suspend.
Suspend bit: (Read/Write)
0: The device is not suspended.
1: The device is suspended.
Suspending the device will conserve power. The host will have limited communications capability with
the device when it is suspended. During this time, the device will only respond to command 0x1C.
Powering the device down will conserve more power than suspending it. It takes more time to power the
device up than it does to take it out of suspend.
Ready bit: (Read only, always write 0)
0: The device is not ready.
1: The device is ready.
The host will have limited communications capability with the device when it is powered down or
suspended. During this time, the device will only respond to command 0x1C. Because it takes some time
for the device to be capable of full communication after powering it up or taking it out of suspend, this
flag can be read to determine whether the device is ready for full communication.
3.4.23
Command 0x1D - Set Bluetooth LE Module Control Data (Bluetooth LE Only)
This command sends control data to the Bluetooth LE module, which controls Bluetooth LE
communications. The device will first respond with
. After the
Bluetooth LE module control data is processed, the device will respond with
LE Module Control Data (Bluetooth LE Only)
. It is important to understand that even though this is
implemented as a feature report to be used in Set mode, it can be used to send requests to discover the
current property settings in the Bluetooth LE module. The full set of Bluetooth LE module controls can
be found in
